How to check qlc driver version

These steps only apply to:. Using fcinfo Command:. For Solaris 10 U1 or above —. Command: fcinfo hba-port. Model: Firmware Version: 2. Model: xx Firmware Version: 2. Using prtpicl Command:. Firmware Maintenance 4.

Reset Adapter 5. Persistent Bindings. PCI Configuration Parameters 2. Adapter Revision Levels 3. Wakeup Parameters 4. IEEE Address 5. Loop Map 6. Link Status 8. Configuration Parameters. Jun 4 somehost qla ID kern. SCLI is qlogic only. It is the qlogic management utility. The fcinfo and prtcipl commands will work with any fiber HBA.

Open storage Explorer of Windows Server R2. Membership in the local Administrators group, or equivalent, is the minimum required to complete this procedure.

FFC Device Specific. Please note that this document is a translation from English, and may have been machine-translated. It is possible that updates have been made to the original version after this document was translated and published. Veritas does not guarantee the accuracy regarding the completeness of the translation.

You may also refer to the English Version of this knowledge base article for up-to-date information. To disable it on several hosts it is easier using PowerCLI. However you still need to reboot each host after running the command. To check the status of the driver on each host, showing if the driver is enabled and loaded, I used this PowerCLI one-liner.

To also check the qfle3 driver version, I used the following one-liner, which admittedly is pretty ugly and probably not optimal, but it allowed me to quickly check hundreds of hosts. For these I enabled the bnx2x driver and disabled qfle3.